Support and Printing tips

Instructions and printing tips can be found on the specific resin pages.

When printing with the Form2 printer, K-Lab recommends the use of the Formlabs LT tank or removal of the resin from an orange tank, as per the guidelines on the resin pages.

Prints on the Formlabs Form2 should be performed with the resin at 25 degrees celsius or higher. This can be achieved by switching off the open mode and allowing the resin to heat before turning on the open mode and printing.

If you would like assistance to use Apply Lab Work resin on a printer that is not mentioned on K-Lab.com.au please feel free to get in contact with us at info@k-lab.com.au for advice.